We diagnose, repair, and tune FDM 3D printers. From a clogged hotend to a complete rebuild — bring it in and we'll get it printing again.
We work on most consumer and prosumer FDM printers. All repairs are quoted individually before any work begins.
Not sure what's wrong? Bring your printer in and we'll run a full diagnostic — checking electronics, motion system, hotend, and bed leveling — then give you a clear report.
Clogs, stripped gears, heat creep, and broken heater blocks. We stock common hotend components and can usually turn these around same-day.
First-layer adhesion issues, uneven beds, Z-offset problems. We'll get your printer dialed in for consistent, reliable results every print.
Faulty mainboards, broken displays, stepper driver issues, and firmware flashing. We can diagnose and replace control boards and update firmware configurations.
Belt tension, loose pulleys, worn linear rails, and frame alignment. A well-tuned motion system is the foundation of print quality.
Sometimes a printer needs more than a single fix. We offer complete teardown and rebuild service, and can install upgrades like direct drive conversions or auto-leveling sensors.
If your brand isn't listed, reach out — we can likely still help.
Don't see your printer? Contact us — we'll let you know if we can help.
Common symptoms and what they usually mean.
Contact us to arrange a drop-off. We'll assess your printer and give you a clear repair estimate before doing any work.
Contact Us